Connecting To A Power Source - Savin IS200e Operating Instructions Manual

Setting Up the Scanner

Connecting to a Power Source

This section explains how to connect
this machine to a power source, using
the bundled AC power cord.
R WARNING:
2
• Do not use with a power
source with a voltage different
from the specified voltage. Do
not use a power outlet with
multiple devices plugged in.
These could create the risk of
fire or electric shock.
• Avoid the use of an extension
cord.
• Do not damage, break, twist or
modify the Power Cord. Plac-
ing heavy objects on the cord,
pulling on or bending it exces-
sively can damage the Power
Cord, creating the risk of fire
or electric shock.
• Never touch or unplug the
power plug with wet hands.
This can create the risk of elec-
tric shock.
R CAUTION:
• When unplugging from an outlet,
be sure to grasp the plug when
pulling. Never pull on the cord.
This could damage the cord cre-
ating the risk of fire or electrical
shock.
A A A A
Confirm that the power switch is
set to off.
30
B B B B
Confirm that the lock switch lo-
cated at the right side of the ma-
ch ine is se t to th e " U nlock "
position.
Important
❒ Be sure to confirm the Lock
Switch Status Display shows
"Unlock", at the right side panel.
Turning on the power with this
lock switch set to "Lock" could
result in failure in scanning or
malfunction of this machine.
C C C C
Push the power cord plug all the
way into the power connector on
this machine.
Note
❒ Be sure to use the power cord
that comes with this machine.
D D D D
Insert the power plug into the
power outlet.
AFJ053S
AFJ059S