Show Errdisable Recovery - Cisco ME 3400 Command Reference Manual

show errdisable recovery

show errdisable recovery
Use the show errdisable recovery user EXEC command to display the error-disable recovery timer
information.
Syntax Description | begin
| exclude
| include
expression
Command Modes User EXEC
Command History Release
12.2(25)EX
Usage Guidelines Expressions are case sensitive. For example, if you enter | exclude output, the lines that contain output
are not displayed, but the lines that contain Output are displayed.
A gbic-invalid error-disable reason refers to an invalid small form-factor pluggable (SFP) module
interface.
Examples This is an example of output from the show errdisable recovery command:
Switch> show errdisable recovery
ErrDisable Reason
-----------------
udld
bpduguard
security-violatio
channel-misconfig
vmps
pagp-flap
dtp-flap
l2ptguard
link-flap
psecure-violation
gbic-invalid
dhcp-rate-limit
unicast-flood
storm-control
arp-inspection
loopback
Timer interval:300 seconds
Cisco ME 3400 Ethernet Access Switch Command Reference
2-384
show errdisable recovery [ | {begin | exclude | include} expression]
(Optional) Display begins with the line that matches the expression.
(Optional) Display excludes lines that match the expression.
(Optional) Display includes lines that match the specified expression.
Expression in the output to use as a reference point.
Modification
This command was introduced.
Timer Status
--------------
Disabled
Disabled
Disabled
Disabled
Disabled
Disabled
Disabled
Disabled
Enabled
Disabled
Disabled
Disabled
Disabled
Disabled
Disabled
Disabled
Chapter 2 Cisco ME 3400 Ethernet Access Switch Cisco IOS Commands
OL-9640-07