Show Lacp - Cisco ME 3400 Command Reference Manual

show lacp

show lacp
Use the show lacp user EXEC command to display Link Aggregation Control Protocol (LACP)
channel-group information.
LACP is available only on network node interfaces (NNIs) or enhanced network interfaces (ENIs).
Note
Syntax Description channel-group-number
counters
internal
neighbor
sys-id
| begin
| exclude
| include
expression
Command Modes
User EXEC
Command History Release
12.2(25)EX
Usage Guidelines
You can enter any show lacp command to display the active channel-group information. To display
specific channel information, enter the show lacp command with a channel-group number.
If you do not specify a channel group, information for all channel groups appears.
You can enter the channel-group-number option to specify a channel group for all keywords except
sys-id.
Expressions are case sensitive. For example, if you enter | exclude output, the lines that contain output
do not appear, but the lines that contain Output appear.
Cisco ME 3400 Ethernet Access Switch Command Reference
2-450
show lacp [channel-group-number] {counters | internal | neighbor | sys-id} [ | {begin | exclude |
include} expression]
(Optional) Number of the channel group. The range is 1 to 48.
Display traffic information.
Display internal information.
Display neighbor information.
Display the system identifier that is being used by LACP. The system
identifier is made up of the LACP system priority and the switch MAC
address.
(Optional) Display begins with the line that matches the expression.
(Optional) Display excludes lines that match the expression.
(Optional) Display includes lines that match the specified expression.
Expression in the output to use as a reference point.
Modification
This command was introduced.
Chapter 2 Cisco ME 3400 Ethernet Access Switch Cisco IOS Commands
OL-9640-07