Uni Count - Cisco ME 3400 Command Reference Manual

Chapter 2 Cisco ME 3400 Ethernet Access Switch Cisco IOS Commands

uni count

Use the uni count EVC configuration command to set the user-network interface (UNI) count for an
Ethernet virtual connection (EVC). Use the no form of this command to return to the default setting.
This command is available only if your switch is running the metro IP access or metro access image.
Syntax Description value
multipoint
Defaults The default UNI count is 2. The default service, if you do not enter a UNI count, is point-to-multipoint.
Command Modes EVC configuration
Command History Release
12.2(25)SEG
Usage Guidelines The UNI count determines the type of service in the EVC.
•
•
•
You should know the correct number of maintenance end points (MEPs) in the domain. If you enter a
UNI count value greater than the actual number of endpoints, the UNI status shows as partially active
even if all endpoints are up. If you enter a UNI count less than the actual number of endpoints, UNI status
shows as active, even if all endpoints are not up.
Configuring a UNI count does not prevent you from configuring more endpoints than the configured
Caution
count. For example, if you configure a UNI count of five, but you create ten MEPs, any five MEPs in the
domain can go down without the status changing to Partially Active.
OL-9640-07
uni count value [multipoint]
no uni count
Set the number of UNIs in the EVC. The range is from 1 to 1024. The default is 2.
(Optional) Select point-to-multipoint service. This keyword is visible only when
you enter a uni count value of 2.
If you do not enter a value or if you enter 1 or 2, the service defaults to
•
point-to-point service. If you enter 2, you can configure point-to-multipoint
service.
If you enter a uni count value of 3 or greater, the service is
•
point-to-multipoint.
Modification
This command was introduced.
If the command is not entered, the UNI count defaults to 2 and the service defaults to point-to-point
service.
If you manually enter a value of 2, you can leave the service at the default or can configure
point-to-multipoint service by entering the multipoint keyword.
If you enter a value of 3 or greater, the service is point-to-multipoint.
Cisco ME 3400 Ethernet Access Switch Command Reference
uni count
2-653