Cisco ME 3400 Command Reference Manual page 829

Ethernet access switch

Hide thumbs Also See for ME 3400:

Table of Contents

Cisco ME 3400 Ethernet Access Switch Show Platform Commands

This is an example of output from the show platform policer cpu classification command:

Switch# show platform policer cpu classification

==================================================

==================================================

==================================================

SWITCH_ROUTER_MAC

This example of the output from the show platform policer cpu interface command shows the default

policer configuration for a UNI. Because the port is Fast Ethernet 1, the identifier for rate-limited

protocols is 0; a display for Fast Ethernet port 5 would display an identifier of 4. The Policer Index refers

to the specific protocol. The ASIC number indicates when the policer is on a different ASIC.

Because UNIs do not support STP, CDP, LLDP, LACP, and PAgP, these packets are dropped (physical

policer of 26). These protocols are disabled by default on ENIs as well, but you can enable them. When

enabled on ENIs, the control packets are rate-limited and a rate-limiting policers is assigned to the port

for these protocols (physical policer of 22).

Switch# show platform policer cpu interface fastethernet 0/3

Policers assigned for CPU protection

===================================================================

===================================================================

SWITCH_ROUTER_MAC

Cisco ME 3400 Ethernet Access Switch Command Reference

show platform policer cpu

Show Quick Links

Table of Contents