Rep Stcn - Cisco ME 3400 Command Reference Manual

Chapter 2 Cisco ME 3400 Ethernet Access Switch Cisco IOS Commands

rep stcn

Use the rep stcn interface configuration command on a Resilient Ethernet Protocol (REP) edge port to
configure the port to send REP segment topology change notifications (STCNs) to another interface, to
other segments, or to Spanning Tree Protocol (STP) networks. Use the no form of this command to
disable the sending of STCNs to the interface, segment, or STP network.
Syntax Description interface interface-id Identify a physical interface or port channel to receive STCNs.
segment id-list
stp
Defaults
Transmission of STCNs to other interfaces, segments, or STP networks is disabled.
Command Modes Interface configuration
Command History Release
12.2(40)SE
Usage Guidelines
Enter this command on a segment edge port.
You use this command to notify other portions of the Layer 2 network of topology changes that occur in
the local REP segment. This removes obsolete entries in the Layer 2 forwarding table in other parts of
the network, which allows faster network convergence.
Examples
This example shows how to configure the REP primary edge port to send STCNs to segments 25 to 50:
Switch (config)# interface gigabitethernet0/2
Switch (config-if)# rep stcn segment 25-50
Switch (config-if)# exit
You can verify your settings by entering the show interfaces rep detail privileged EXEC command.
Related Commands Command
show interfaces rep
[detail]
OL-9640-07
rep stcn {interface interface-id | segment id-list | stp}
no rep stcn {interface | segment | stp}
Identify one REP segment or list of segments to receive STCNs. The range is 1
to 1024. You can also configure a sequence of segments (for example 3-5, 77,
100).
Send STCNs to an STP network.
Modification
This command was introduced.
Description
Displays REP configuration and status for all interfaces or the specified
interface.
Cisco ME 3400 Ethernet Access Switch Command Reference
rep stcn
2-321