Speed - Cisco ME 3400 Command Reference Manual

speed

speed
Use the speed interface configuration command to specify the speed of a 10/100 Mbps or
10/100/1000 Mbps port. Use the no or default form of this command to return the port to its default
value.
For speed configurations restrictions on small form-factor pluggable (SFP) module ports, see the "Usage
Note
Guidelines" section.
Note You cannot configure the speed on small form-factor pluggable (SFP) module ports, but you can
configure the speed to not negotiate (nonegotiate) if they are connected to a device that does not support
autonegotiation. See "Usage Guidelines" for exceptions when a 1000BASE-T SFP module is in the SFP
module slot.
Syntax Description 10
100
1000
auto
nonegotiate
Defaults The default is auto.
Command Modes
Interface configuration
Command History Release
12.2(25)EX
Usage Guidelines You can configure the Fast Ethernet port speed as either 10 or 100 Mbps.
You can configure the Gigabit Ethernet port speed as 10, 100, or 1000 Mbps.
When a 1000BASE-T SFP module is in the SFP module slot, you can configure the speed as 10, 100,
1000, or auto but not to nonegotiate.
Cisco ME 3400 Ethernet Access Switch Command Reference
2-600
speed {10 | 100 | 1000 | auto [10 | 100 | 1000] | nonegotiate}
no speed
Port runs at 10 Mbps.
Port runs at 100 Mbps.
Port runs at 1000 Mbps. This option is valid and visible only on 10/100/1000
Mbps-ports.
Port automatically detects the speed it should run at based on the port at the other
end of the link. If you use the 10, 100, or 1000 keywords with the auto keyword, the
port only autonegotiates at the specified speeds.
Autonegotiation is disabled, and the port runs at 1000 Mbps. (The 1000BASE-T SFP
does not support the nonegotiate keyword.)
Modification
This command was introduced.
Chapter 2 Cisco ME 3400 Ethernet Access Switch Cisco IOS Commands
OL-9640-07