Cisco ME 3400 Command Reference Manual page 358

service-policy (interface configuration)
Examples This example shows how to apply plcmap1 as an output policy map:
Switch(config)# interface gigabitethernet0/1
Switch(config-if)# service-policy output plcmap1
This example shows how to remove plcmap2 from the port:
Switch(config)# interface gigabitethernet0/2
Switch(config-if)# no service-policy output plcmap2
You can verify your settings by entering the show running-config privileged EXEC command.
Related Commands Command
policy-map
show policy-map
show policy-map
interface [interface-id]
show running-config
Cisco ME 3400 Ethernet Access Switch Command Reference
2-332
Chapter 2 Cisco ME 3400 Ethernet Access Switch Cisco IOS Commands
Description
Creates or modifies a policy map that can be attached to multiple ports to
specify a service policy.
Displays quality of service (QoS) policy maps.
Displays policy maps configured on the specified interface or on all
interfaces.
Displays the operating configuration. For syntax information, use this link to
the Cisco IOS Release 12.2 Command Reference listing page:
http://www.cisco.com/en/US/products/sw/iosswrel/ps1835/prod_command
_reference_list.html
Select the Cisco IOS Commands Master List, Release 12.2 to navigate to
the command.
OL-9640-07