Dot1X Test Timeout - Cisco ME 3400 Command Reference Manual

Chapter 2 Cisco ME 3400 Ethernet Access Switch Cisco IOS Commands

dot1x test timeout

Use the dot1x test timeout global configuration command to configure the timeout used to wait for
EAPOL response from a port being queried for IEEE 802.1x readiness.
Syntax Description timeout
Defaults
The default setting is 10 seconds.
Command Modes
Global configuration
Command History Release
12.2(44)SE
Usage Guidelines
Use this command to configure the timeout used to wait for EAPOL response.
There is not a no form of this command.
Examples This example shows how to configure the switch to wait 27 seconds for an EAPOL response:
Switch# dot1x test timeout 27
You can verify the timeout configuration status by entering the show run privileged EXEC command.
Related Commands Command
dot1x test eapol-capable
interface-id]
OL-9640-07
dot1x test timeout timeout
Time in seconds to wait for an EAPOL response. The range is from
1 to 65535 seconds.
Modification
This command was introduced.
[interface
Description
Checks for IEEE 802.1x readiness on devices connected to
all or to specified IEEE 802.1x-capable ports.
Cisco ME 3400 Ethernet Access Switch Command Reference
dot1x test timeout
2-85