Step 3: Position Compensation - Omron F160 Operation Manual

Setting Inspection Conditions
2-4-2-6 Calibration
CHECK
2-4-3

STEP 3: Position Compensation

SHIFT+Right Keys: Increases the value in 10s.
Left Key: Reduces the lowest digit by one.
SHIFT+Left Keys: Decreases the value in 10s.
Up and Down Keys: Switches between setting items.
3. Use the same method to change the lower value.
4. Select OK.
The settings will be registered and the screen in (1.) will return.
Calibration can be set to output the measurement results in physical units.
Set the relationship between the physical coordinates and the camera coordi-
nates to convert the measurement results from pixels to physical units, such
as µm, mm, or cm.
This section gives an outline only. Refer to SECTION 4 Detailed Setting Oper-
ations (page 185) for details on calibration.
To output measurement results in physical units, set Coordinate mode/Calibra-
tion to ON for each measurement item.
If Calibration remains set to OFF, the default settings will remain, and mea-
surements using the Camera coordinates will be output.
The position displacement compensation function is used when the position
and orientation of measurement objects are not consistent. By using this func-
tion, the displacement between the reference position and the current position
is obtained, and this displacement is compensated for in measurements.
This section gives an outlined only. Refer to SECTION 4 Detailed Setting
Operations (page 197) for details on position compensation.
Reference Position
The measurement region and measurement object are in the correct posi-
tions.
Section 2-4
Measurement region
Measurement object
45