Table of Contents
Advertisement
OMRON
Precautions for Installation
This section describes the procedures involved in the installation of CX-Programmer on a standard workstation
running Microsoft Windows 2000 or XP.
♦ Close all programs running on Windows before starting the installation procedure.
♦ Do not stop the setup process in the middle. Copied files may remain in the installation directory.
♦ Do not turn OFF or reset the computer in the middle of the installation process. Computer data may become
corrupted.
♦ On Windows 2000, or XP, the administrator or a user with administrator rights must perform the
installation. Other users will not have sufficient write permissions and access errors will occur.
♦ With Windows 2000, always use service pack 2. The service pack can be confirmed by selecting Start -
Settings - Control Panel - System. The service pack will be displayed under System on the General Tab
Page of the System Properties Dialog Box. If a service pack is not displayed, no service pack has been
installed. Refer to Microsoft's website for service pack installation methods.
♦ It may be necessary to restart Windows after finishing the installation. If required, restart Windows
according to the messages displayed by the Installer.
Note:
Internet Explorer version 5.0 or higher must be installed in advance to use the CX-Server
Installer. Install Internet Explorer version 5.0 in advance if it is not already installed.
PART 1: CX-Programmer
CHAPTER 1 – Technical Specifications
CX-Programmer _Page 7
Advertisement
Chapters
Table of Contents
