Omron CX-PROGRAMMER V9 - REV 12-2009 Operation Manual page 84

PART 1: CX-Programmer
CHAPTER 1 – Technical Specifications
• Installing the CX-Programmer from the Individual CX-Programmer CD-ROM
Item
Computer
Processor
RAM Program
Memory size of 30
Ksteps or
less
(See note 2.)
Program
size of 120
Ksteps or
less
(See note 2.)
Program
size of 120
Ksteps or
more
(See note 2.)
Hard Disk Space
Display
CD-ROM Drive
Communications Port
Note 1: The amount of memory (RAM) required depends on the size of the programs being created.
Note 2: The program sizes assume that only one PLC is registered. If more than one PLC is registered
Note 3: Some Help files cannot be accessed when CX-Programmer is used with Microsoft Windows
• Installing the CX-Programmer from the CX-One Package CD-ROM
Refer to the CX-One Setup Manual (Cat. No. W463) for the conditions required if the CX-Programmer
has been installed from the CX-One CD-ROM.
CX-Programmer _Page 4
Minimum System Requirements
Microsoft Windows
2000 Service Pack 2
or later or Windows
XP
IBM PC/AT or
compatible
Pentium Class
330 MHz minimum
Pentium III Class
1 GHz or faster
recommended.
128 MB min.
(192 MB min. when
CX-Simulator is also
used.)
256 MB min.
(256 MB min. when
CX-Simulator is also
used.)
384 MB min.
(384 MB min. when
CX-Simulator is also
used.)
550 MB minimum free
space
SVGA (800x600) or
better
One drive min.
One RS-232C port
min.
The CX-Programmer operation may slow significantly if the memory requirements exceed the
computer's available memory.
in a project, the memory size of the computer must be increased by approximately 1 MB per
1 Kstep of PLC program.
Vista. These Help files can be accessed if the Help program for Windows Vista from
Microsoft (WinHlp32.exe) is installed. For installation information, refer to the Microsoft
homepage listed below or contact Microsoft Corporation. (The download page is
automatically displayed when the Help file is opened when connected to the Internet.)
http://support.microsoft.com/kb/917607/en_us
Microsoft Windows
Vista
(See note 3.)
IBM PC/AT or
compatible personal
computer that uses a
processor
recommended by
Microsoft.
Processor
recommended by
Microsoft (1 GHz or
faster recommended.)
512 MB min. of
memory is required. 1
GB or more is
recommended.
550 MB minimum free
space
SVGA (800x600) or
better
One drive min.
One RS-232C port
min.
OMRON