Omron CX-PROGRAMMER V9 - REV 12-2009 Operation Manual page 176

PART 1: CX-Programmer
CHAPTER 4 – Reference
By default, symbol names and I/O comments are created automatically according to the following rules.
Item
Symbol name
I/O comment
To change the automatic generation rule from the default, click the Advanced Button in the Address Incremental
Copy Dialog Box and change the setting as shown below.
CX-Programmer _Page 96
4. Click the Paste Button.
The addresses will be automatically incremented and the program section will be
automatically pasted. The I/O comments will be automatically created.
Rule for automatic
creation
Increment the numbers
found from tail.
Increment the numbers
found from tail.
Contents
Symbol names are searched for numbers
from the end and the first number that is
found is incremented. If a number is not
found, a serial number is added following
an underscore character.
I/O comments are searched for numbers
from the end and the first number that is
found is incremented. If a number is not
found, a serial number is added following
an underscore character.
OMRON
Example
If Name1_1 is found, then
Name1_2 is automatically
created.
If Cmt1_1 is found, then
Cmt1_2 is automatically
created.