Omron CX-PROGRAMMER V9 - REV 12-2009 Operation Manual page 23

Functions Supported by Unit Version 3.0 or Later
CS1-H CPU Units (CS1@-CPU@@H)
Function
Function blocks (supported for CX-Programmer Ver.
5.0 or higher)
Serial Gateway (converting FINS commands to
CompoWay/F commands at the built-in serial port)
Comment memory (in internal flash memory)
Expanded simple backup data
New TXDU(256), RXDU(255) (support
application no-protocol communications with
instructions Serial Communications Units with
unit version 1.2 or later)
Model conversion instructions:
XFERC(565), DISTC(566),
COLLC(567), MOVBC(568),
BCNTC(621)
Special function block instructions:
GETID(286)
Additional TXD(235) and RXD(236)
instruction instructions (support no-protocol
functions communications with Serial
Communications Boards with unit
version 1.2 or later)
New ASCII conversion instructions
application (NUMBER-TO-ASCII and ASCII-
instructions TO- NUMBER)
Text File Write (TWRIT)
Improved Online editing of function blocks
function block
Input-output variables are
(FB) functions
supported.
(Input-output variables can be
specified in arrays.)
The STRING data type and text-
string processing functions are
supported in ST language.
Using ST language programming in tasks
Using SFC programming in tasks
Note: CX-Programmer version 7.0 or higher is required to use functions added for unit version
4.0. Additional functions are supported if CX-Programmer version 7.2 or higher is used.
CS1D CPU Units
Unit version 3.0 (Ver. 3.0) is not supported.
Pre-Ver. 2.0, Ver.
2.0
--- OK
--- OK
--- OK
--- OK
--- OK
--- OK
--- OK
--- OK
--- ---
--- ---
--- ---
--- ---
--- ---
--- ---
Unit version
Ver. 3.0
(See note.)
OK
OK
OK
OK
OK
OK
OK
OK
OK
OK
OK
OK
OK with CX-
Programmer Ver. 7.2
or higher
OK with CX-
Programmer Ver. 7.2
or higher
CX-Programmer_Page (
Ver. 4.0
xx
)