Omron CX-PROGRAMMER V9 - REV 12-2009 Operation Manual page 412

PART 2: CX-Server PLC Tools
CHAPTER 12 – PLC Backup Tool
Checking Restore Data
When the configuration information in the backup file is displayed in the Restore to PLC Dialog Box, you can
start the Support Software for specific Units to check the data before restoring it to the Unit. This function is
supported for the following Units.
♦ Applicable Units and Support Software
Unit
CPU Unit
Controller Link Unit, SYSMAC
LINK Unit, Ethernet Unit, or
EtherNet/IP Unit
Serial Communications
Unit/Board
FL-net Unit
Other Special I/O Units
Procedure
1, 2, 3...
CX-Server PLC Tools_Page 162
Data
Program Parameters
Unit parameters
• Unit parameters
• Protocol macros
Unit parameters
Unit parameters
Note: Parameters can only be checked. They cannot be edited or transferred.
If you select the target Unit and click the Start a tool Button, the following Confirm Tool
1.
Startup Dialog Box will be displayed.
Click the OK Button. The View Parameters Dialog Box or Start a Tool Dialog Box will be
2.
displayed, depending on the target Unit that was selected. If the Start a Tool Dialog Box
was displayed, a list of Support Software will be displayed. Select the Support Software to
start and click the OK Button.
Support Software
CX-Programmer
View Parameters Dialog Box (Select
displaying Special I/O Units and CPU
Bus Units.) (See note.)
View Parameters Dialog Box (See
note.)
(Select displaying Special I/O Units and
CPU Bus Units.) CX-Protocol
CX-FLnet
View Parameters Dialog Box (See
note.)
(Select displaying Special I/O Units and
CPU Bus Units.)
OMRON
Comments
The routing tables are
not displayed.
The routing tables are
not displayed.
---
---