Omron CX-PROGRAMMER V9 - REV 12-2009 Operation Manual page 376

PART 2: CX-Server PLC Tools
CHAPTER 10 – Data Links
♦ Controller Link
Select Automatic.
(If Manual is
selected, data link
tables created by
the user will be
used.)
If Automatic is
selected, data link
parameters can be
set.
When Read or
Write is executed,
the results are
displayed here.
5 Select Start or Stop in the Power Up Run State field.
♦ Controller Link
Make the settings for Area
1. Set the area for
executing the data links,
the start word, and the
size.
Make the settings for Area
2. Set
executing the data links,
the start word, and the
size.
7 Set the automatic data link setup parameters.
CX-Server PLC Tools_Page 126
Note:
Selecting Start causes the data links to start when the PLC is powered up, without
having to perform any other data link startup operation.
When Automatic is selected, the automatic data link setup parameters can be set, as
shown below.
the area for
Reads settings
data from the PLC.
Transfers settings
data to the PLC.
Select Start in
order to have data
links start when the
PLC is started.
Set the status start
word.
Set the nodes
participating in the
data links.
OMRON