Omron CX-PROGRAMMER V9 - REV 12-2009 Operation Manual page 306

PART 2: CX-Server PLC Tools
CHAPTER 5 – Data Trace/Time Chart Monitor Component
Data Trace Execution
1 Select [Operation]| [Execute] on Data Trace Window. (Or click on
Trigger can be completed with [Execute]| [Trigger] (or
2 When Data Trace starts and trigger conditions are completed, sampling will start. Trace data will be saved to
trace memory of CPU Unit.
When trace memory is full, sampling automatically stops. Trace data will be read from trace memory of
CPU Unit. Data trace screen will be displayed in Data Trace window.
3 When stopping Data Trace before trace memory is full, select [Operation]| [Stop] (Or click on
When Data Trace is interrupted, select [Operation]| [Read] (Or click on
Operation of Data Trace Window for CS/CJ/CP
Following is the operation procedure of Data Trace.
Check on [Show] of the data to be shown on [Legend View] tab. Uncheck will be Hide.
♦ Check on [Select] of [Legend View] or click on a graph. Trace data is selected.
♦ Graph tool bar will appear to the selected data. Move up and down (offset change), scale in and
♦ Move up and down (offset change) is possible with dragging a graph directly.
♦ Select [Trace Settings] tab to check trace settings.
♦ Select [Properties] tab to refer to trace properties.
♦ Right click on trace screen and select [Copy to Clipboard]. Paste the graph screen to the paint and so on is
possible.
♦ Right click on trace screen and select [Save to Bitmap]. Save as a bit map file is possible.
CX-Server PLC Tools_Page 56
out (scale change) and input of graph show units are possible with tool bar operation.
)
).
). Data Trace screen will appear.
OMRON
).