Omron CX-PROGRAMMER V9 - REV 12-2009 Operation Manual page 342

PART 2: CX-Server PLC Tools
CHAPTER 10 – Data Links
View
Table
Online
Options
Help
CX-Server PLC Tools_Page 92
Menu Sub-menus/
Commands
Exit
Move Right
Move Left
Move Up
Move Down
Change Window
Zoom Out
Zoom In
Zoom Original
Show in List
Show in Table
Show Func Bar
Show Offset
Wizard
Add Source Link
Add Destination
Delete
Validate Table
Table Information
Show Node List
Redraw
Transfer from PLC
Transfer to PLC
Verify Node
Data Link
Operation/Status
Automatic Data
Link Setup
Set All Nodes for
Network Operation
Show All Network
Nodes
Delete
Cycle Time
Exits the Datalink Component window.
Moves the cursor to the right in the Data Link Configuration window.
Moves the cursor to the left in the Data Link Configuration window.
Moves the cursor up in the Data Link Configuration window.
Moves the cursor down in the Data Link Configuration window.
Changes the active window.
Zooms out from within the Data Link Configuration window.
Zooms in within the Data Link Configuration window.
Returns the Data Link Configuration window to its initial scale.
Shows the Data Link Area settings in list format.
Shows the Data Link Area settings in table format.
Shows function key guides at the bottom of the Datalink Component
window. (Enabled for table format only.)
Shows the specified offset value on the Node Editing window.
Executes the Datalink Wizard.
Adds a node to the data links.
Adds the receive area of a participating node to the data links.
Deletes nodes.
Checks data link tables.
Edits data link table information.
Displays a list of nodes.
Resets colored displays.
Uploads online data link tables to the computer.
Downloads online data link tables from the computer to a PLC.
Compares data link tables generated by CX-Net with data link tables
stored in the PLC. If they do not match, a error dialog box is displayed.
Displays the operation and data link status of manually set data links.
Sets parameters for automatically set data links, and transfers them to
the startup node.
Executes transfer, verify, and delete operations for all nodes.
Reads data link tables from all nodes.
Deletes data link tables.
Sets the communications cycle time (for SYSMAC LINK data link
tables only).
Displays help.
Function
OMRON