Omron CX-PROGRAMMER V9 - REV 12-2009 Operation Manual page 465

OMRON
1. Register the PLC to be connected serially (using Host Link FINS) in the project gateway (e.g.,
2. In the Change PLC Dialog Box of the target PLC (e.g., PLC1), select the relay PLC (gateway
3. The Network Settings Dialog Box will be displayed. Click the Guide for Serial Gateway
4. The Serial Gateway Guide Dialog Box will be displayed. Select the unit and the port number
Revision 2.0
System Configuration Example
Serial Communications Board/Unit with unit Ver.1.2 or later
(Select SCU (Unit 0 to 15) in the UNIT field.)
Serial Gateway function port (Select
port 1/2 in the PORT field according
to the calculated address.)
Serial
Gateway
Host Link FINS
PLC2).
PLC) in the Network Type pull-down menu (e.g., [PLC2] (See note.)) and click the Settings
Button to the right of the Network Type pulldown menu.
Note The PLC name enclosed in square brackets (e.g., [PLC2]) indicates the gateway PLC.
Select the relay PLC (e.g., [PLC2]) as the
network type.
Button.
Click this button.
under the Calculate Address Area.
Set the relay PLC.
(Select in the Change PLC Dialog Box.)
Device Name: PLC2
Select the Use SYSWAY with the port option in the Host Link
(SYSWAY) settings.
Device Name: PLC1
Target PLC Host Link unit number
Enter the Host Link unit number in the Host Link Unit Number field for
the target PLC in the Host Link (SYSWAY) settings.
PART 3: CX-Server Runtime
CHAPTER 3 – Communications
CX-Programmer Ver.5.0 or later
Network Type:
Select [PLC2].
CX-Server Runtime_Page 21