Static Route Add/Edit Screen - ZyXEL Communications USG FLEX H Series User Manual

Figure 103 Network > Routing > Static Route
The following table describes the labels in this screen.
Table 76 Network > Routing > Static Route
LABEL
Add
Edit
Remove
Name
Destination
Next-Hop
Metric
Apply
Reset

8.3.1 Static Route Add/Edit Screen

Click Network > Routing > Static Route > Add/Edit to display the next screen. Use this screen to configure
the required information for a static route.
Chapter 8 Routing
DESCRIPTION
Click this to create a new static route.
Double-click an entry or select it and click Edit to open a screen where you can modify the
entry's settings.
To remove an entry, select it and click Remove. The Zyxel Device confirms you want to
remove it before doing so.
This is the name of the static route entry.
This is the destination IP address.
This is the IP address of the next-hop gateway or the interface through which the traffic is
routed. The gateway is a router or switch on the same segment as your Zyxel Device's
interface(s). The gateway helps forward packets to their destinations.
This is the route's priority among the Zyxel Device's routes. The smaller the number, the
higher priority the route has.
Click Apply to save your changes back to the Zyxel Device.
Click Reset to return the screen to its last-saved settings.
USG FLEX H Series User's Guide
145