Table of Contents
Advertisement
Chapter 7 Device Advanced Settings
The following table describes the labels in this screen.
Table 82 Device Operation > Device Configuration > Advanced > Static Route
LABEL
#
Route Name
Active
Destination
Gateway
Edit
Remove
7.6.1 Edit Static Route
Use this screen to edit a static route in the device. To open this screen, select a static route, and
click Edit in the Device Operation > Device Configuration > Advanced > Static Route
screen.
Figure 93 Device Operation > Device Configuration > Advanced > Static Route > Edit
The following table describes the labels in this screen.
Table 83 Device Operation > Device Configuration > Advanced > Static Route > Edit
LABEL
Route Name
Active
194
DESCRIPTION
This is the number of an individual entry.
This is the name that describes or identifies this route. To delete a static route,
erase the name and then click apply.
This field shows whether this static route is active or not.
This parameter specifies the IP network address of the final destination. Routing is
always based on network number.
This is the IP address of the gateway. The gateway is an immediate neighbor of the
device that will forward the packet to the destination. On the LAN, the gateway must
be a router on the same segment as the device; over the WAN, the gateway must
be the IP address of one of the remote nodes.
Click Edit to set up a static route on the device.
Click Remove to delete a static route.
DESCRIPTION
Enter the name of the IP static route. Leave this field blank to delete this static
route.
This check box allows you to activate/deactivate this static route.
Vantage CNM User's Guide
Advertisement
Table of Contents
Troubleshooting
