ZyXEL Communications USG FLEX H Series User Manual page 83

• Number of bytes transmitted (so far)
• Duration (so far)
You can look at all established sessions that passed through the Zyxel Device by user, service, source IP
address, or destination IP address. You can also filter the information by user, protocol / service or service
group, source address, and/or destination address and view it by user.
Click Network Status > Session Monitor to display the following screen.
Figure 69 Network Status > Session Monitor
The following table describes the labels in this screen.
Table 44 Network Status > Session Monitor
LABEL DESCRIPTION
View Select how you want the established sessions that passed through the Zyxel Device to be
displayed. Choices are:
• sessions by users - display all active sessions grouped by user
• sessions by services - display all active sessions grouped by service or protocol
• sessions by source IP - display all active sessions grouped by source IP address
• sessions by destination IP - display all active sessions grouped by destination IP address
• all sessions - filter the active sessions by the User, Service, Source IP, and Destination IP, and
display each session individually (sorted by user).
Refresh Click this button to update the information on the screen. The screen also refreshes
automatically when you open and close the screen.
Search Click this to display all sessions in the table below according to the criteria you defined above.
The User, Service, Source Address, Destination Address, Source Country and Destination
Country fields display if you view all sessions.
User This field displays when View is set to all sessions. Type the user whose sessions you want to view.
It is not possible to type part of the user name or use wildcards in this field; you must enter the
whole user name.
Service This field displays when View is set to all sessions. Select the service or service group whose
sessions you want to view. The Zyxel Device identifies the service by comparing the protocol
and destination port of each packet to the protocol and port of each services that is defined.
Source This field displays when View is set to all sessions. Type the source IP address whose sessions you
Address
want to view. You cannot include the source port.
Destination This field displays when View is set to all sessions. Type the destination IP address whose sessions
Address
you want to view. You cannot include the destination port.
Source This field displays when View is set to all sessions. Select the country where the traffic is coming
Country
from.
Chapter 5 Monitor
USG FLEX H Series User's Guide
83