ZyXEL Communications USG FLEX H Series User Manual page 128

Figure 94 Network > Interface > Interface > VTI > Add/Edit
Each field is described in the table below.
Table 68 Network > Interface > > Interface > VTI > Add/Edit
LABEL DESCRIPTION
General Settings
Enable Interface Slide the switch to the right to enable VTI.
Interface Properties
Interface Name This field displays the name of the VPN tunnel interface. This field is read-only.
VPN Rule This field displays the scenario rule the VPN tunnel interface is using.
Zone Select a zone. Make sure that the zone you select does not have traffic blocked by a
security feature such as a security policy.
IP Address Enter the IP address for this interface.
Connectivity Check The interface can regularly check the connection to the gateway you specified to make
sure it is still available. You specify how often the interface checks the connection, how long
to wait for a response before the attempt is a failure, and how many consecutive failures
are required before the Zyxel Device stops routing to the gateway. The Zyxel Device
resumes routing to the gateway the first time the gateway passes the connectivity check.
Enable Select this to turn on the connection check.
Chapter 7 Interfaces
USG FLEX H Series User's Guide
128