Ip Reputation Block List Screen - ZyXEL Communications USG FLEX H Series User Manual

Table 138 Configuration > Security Service > Reputation Filter > IP Reputation > Allow List (continued)
LABEL
Apply
Reset

17.2.2 IP Reputation Block List Screen

Use this screen to create block list entries. The Zyxel Device will block packets coming from the Internet
and going out from the local network that match the listed IPv4 addresses.
Click Security Service > Reputation Filter > IP Reputation > Block List to display the configuration screen
as shown next.
Figure 174 Security Service > Reputation Filter > IP Reputation > Block List
The following table describes the labels in this screen.
Table 139 Configuration > Security Service > Reputation Filter > IP Reputation > Block List
LABEL
Enable
Log
Add
Edit
Remove
Active
Inactive
Chapter 17 Reputation Filter
DESCRIPTION
Click Apply to save your changes back to the Zyxel Device.
Click Reset to return the screen to its last-saved settings.
DESCRIPTION
Select this to bypass checking by this feature (if enabled) and automatically block:
• incoming packets coming from the listed IPv4 addresses.
• outgoing packets going to the listed IPv4 addresses.
Select log if you want the Zyxel Device to create a log recording when there are
incoming or outgoing packets that come from or go to the listed IPv4 addresses.
Select no if you don't want the Zyxel Device to create a log.
Click this to create a new entry.
Select an entry and click this to be able to modify it.
Select an entry and click this to delete it.
To turn on an entry, select it and click Active.
To turn off an entry, select it and click Inactive.
USG FLEX H Series User's Guide
277