Port - ZyXEL Communications USG FLEX H Series User Manual

Each field is described in the table below.
Table 71 Network > Interface > Trunk > Default Trunk > Edit
LABEL
Name
Load Balancing
Setting
Name
Mode
Parameter
Apply
Reset

7.8 Port

Use this screen to configure port settings. Click Network > Interface > Port in the navigation panel to
display the configuration screen.
Chapter 7 Interfaces
DESCRIPTION
This field displays the name of the selected system default trunk.
This field displays the load balancing method use for the default trunk.
Weighted Round Robin (wrr) balances the traffic load between interfaces based on their
respective weights. An interface with a larger weight gets more chances to transmit traffic
than an interface with a smaller weight. For example, if the weight ratio of wan1 and
wan2 interfaces is 2:1, the Zyxel Device chooses wan1 for 2 sessions' traffic and wan2 for 1
session's traffic in each round of 3 new sessions.
The table lists the trunk's member interfaces. This table is read-only.
This column displays the name of the member interfaces.
This field displays Active if the Zyxel Device always attempt to use this connection.
This field displays Passive if the Zyxel Device only use this connection when all of the
connections set to active are down. Only one of a group's interfaces can be set to
passive mode.
This field displays with the weighted round robin load balancing algorithm. Specify the
weight (1~10) for the interface. The weights of the different member interfaces form a
ratio. s
Click this button to save your changes to the Zyxel Device.
Click this button to return the screen to its last-saved settings.
USG FLEX H Series User's Guide
135