ZyXEL Communications USG FLEX H Series User Manual page 209

Figure 142 Object > Address > Address
The following table describes the labels in this screen. See
information as well.
Table 105 Object > Address > Address
LABEL
IPv4 Address Configuration
Add
Edit
Remove
Reference
Name
Type
Address
Reference
14.1.2.1 IPv4 Address Add/Edit Screen
The Object > Address > Address > Add/Edit screen allows you to create a new address or edit an
existing one. To access this screen, go to the Address screen (see
either the Add icon or an Edit icon in the IPv4 Address Configuration section.
Chapter 14 Object
DESCRIPTION
Click this to create a new entry.
Double-click an entry or select it and click Edit to be able to modify the entry's settings.
To remove an entry, select it and click Remove. The Zyxel Device confirms you want to remove
it before doing so.
Select an entry and click Reference to check which settings use the entry.
This field displays the configured name of each address object.
This field displays the type of each address object. "INTERFACE" means the object uses the
settings of one of the Zyxel Device's interfaces.
This field displays the IPv4 addresses represented by each address object. If the object's
settings are based on one of the Zyxel Device's interfaces, the name of the interface displays
first followed by the object's current address settings.
This displays the number of times an object reference is used in a profile.
USG FLEX H Series User's Guide
209
Section 14.1.2.1 on page 209
Section 14.1.2 on page
for more
208), and click