ZyXEL Communications USG FLEX H Series User Manual page 359

Figure 220 System > SNMP
The following table describes the labels in this screen.
Table 176 System > SNMP
LABEL DESCRIPTION
SNMP Enable this to allow to access the Zyxel Device using this service.
Server Port The SSH port is 161 by default. You may change the server port number for a service if
needed, however you must use the same port number in order to use that service for
remote management.
Trap
Destination Type the IP address of the station to send your SNMP traps to.
Community Type the trap community, which is the password sent with each trap to the SNMP manager.
The default is public and allows all requests.
SNMP V1
SNMP V2C Select the SNMP version for the Zyxel Device. The SNMP version on the Zyxel Device must
match the version on the SNMP manager.
SNMP Community
Chapter 24 System
USG FLEX H Series User's Guide
359