Wall-Mounting - ZyXEL Communications USG FLEX H Series User Manual

the rack unstable or top-heavy. Take all necessary precautions to anchor the rack securely before
installing the unit.
Use a #2 Phillips screwdriver to install the screws.
Note: Failure to use the proper screws may damage the unit.
Align one bracket with the holes on one side of the Zyxel Device and secure it with the included bracket
1
screws (smaller than the rack-mounting screws).
Attach the other bracket in a similar fashion.
2
Figure 43 Attach Brackets
After attaching both mounting brackets, position the Zyxel Device in the rack and match up the bracket
3
holes with the rack holes. Secure the Zyxel Device to the rack with the rack-mounting screws.
Figure 44 Mount on Rack
Note: Make sure there is at least 100 mm of clearance at the sides and 100 mm in the rear to
allow air circulation and the attachment of cables and the power cord. When stacking
in a rack, make sure there is at least 40 mm of clearance between Zyxel Devices.

3.2.3 Wall-mounting

Do the following to attach your Zyxel Device to a wall.
Chapter 3 Hardware, Interfaces and Zones
USG FLEX H Series User's Guide
51