ZyXEL Communications USG FLEX H Series User Manual page 376

Maintenance > Diagnostics > Network Tool and then select Test Email Server. See Log & Report > Email
Daily Report to configure what reports to send and to whom.
Click System > Notification > Mail Server to display the following screen.
Figure 230 System > Notification > Mail Server
The following table describes the labels in this screen.
Table 187 System > Notification > Mail Server
LABEL DESCRIPTION
Mail Server Type the name or IP address of the outgoing SMTP server.
Port Enter the same port number here as is on the mail server for mail traffic.
TLS Security Enable this if the mail server uses Transport Layer Security (TLS) for encrypted communications
between the mail server and the Zyxel Device.
STARTTLS Enable this if the mail server uses SSL or TLS for encrypted communications between the mail
server and the Zyxel Device.
Authenticate Enable this if the Zyxel Device authenticates the mail server in the TLS handshake.
Server
Mail From Type the email address from which the outgoing email is delivered. This address is used in
replies.
SMTP Select this check box if it is necessary to provide a user name and password to the SMTP server.
Authentication
User Name This box is effective when you select the SMTP Authentication check box. Type the user name
to provide to the SMTP server when the log is emailed. Use up to 30 characters, including 0-9a-
zA-Z@._-
Chapter 24 System
USG FLEX H Series User's Guide
376