Low Shear Recline Identification - Invacare Solara 3G Service Manual

Installing Stroller Handle
1. Secure the existing stroller handle to the back canes with two mounting screws and locknuts. Tighten securely.
2. Secure the trigger release levers to the stroller handle with mounting screw and locknut inside the housing of the trigger release lever.
Back Cane Assembly for Seating System
Mounting
Screw
Install Seating System/Back Upholstery
1. Perform one of the following:
A. Install the seating system from the wheelchair. Refer to the seating system owner's manual.
B. Install the back upholstery from the wheelchair. Refer to the Solara owner's manual.

Low Shear Recline Identification

1. Review the following component charts, illustrations and FIGURE 17.6 on page 153, FIGURE 17.7 on page 154, and
FIGURE 17.8 on page 155 to ensure correct orientation and mounting holes are used to obtain the desired low shear
recline.
Part No 1160889
Mounting
Screw
Stroller
Handle
Locknuts
FIGURE 17.5 Installing Stroller Handle
SECTION 17—INSTALLING LOW SHEAR RECLINER
Back Cane Assembly for Upholstery
Stroller
Handle
Mounting
Screw
149
Mounting
Screw
Locknuts
Solara®3G/Spree 3G