Remove The Back Upholstery Or Seating System; Install Spreader Bars - Invacare Solara 3G Service Manual

SECTION 11—VENT TRAY

Remove the Back Upholstery or Seating System

Back Upholstery
NOTE: For this procedure, refer to FIGURE 11.14.
1. Remove the mounting screws and washers that secure the back upholstery to the back canes.
2. Remove the back upholstery from the back canes.
Seating System
NOTE: If wheelchair is equipped with seating system, remove the seating system. Refer to the seating system owner's manual.

Install Spreader Bars

NOTE: For this procedure, refer to FIGURE 11.15.
NOTE: If wheelchair already has a spreader bar, only one of the new spreader bars in the kit will be needed.
1. Secure spreader bars to back canes in the desired location with four 1
securely.
1
1 /
Solara®3G/Spree 3G
Back Cane
FIGURE 11.14 Remove the Back Upholstery or Seating System
Mounting
2
Screws
FIGURE 11.15 Install Spreader Bars
1
Locknuts
106
Back Upholstery
Washer
Mounting Screw
/ inch mounting screws and locknuts. Tighten
2
1
1 / Mounting
2
Screws
Part No 1160889