Install The Vent Tray; Install Foot Tilt Release Pedal And New Connecting Link - Invacare Solara 3G Service Manual

Install the Vent Tray

1. Install the Vent Tray. Refer to Installing Vent Tray Attaching Components on page 98.

Install Foot Tilt Release Pedal and New Connecting Link

NOTE: For this procedure, refer to FIGURE 11.9, FIGURE 11.10 on page 103, and FIGURE 11.11 on page 104.
1. Position the new foot tilt release pedal over the vent tray support tube (FIGURE 11.9).
2. Secure the foot tilt release pedal to the vent tray support tube with 2
11
two coved spacers,
NOTE: Vent tray and attaching
brackets not shown for clarity.
3. Secure the vent foot tilt connecting link to actuator tube assembly with 1 inch mounting screw, two nylon washers, nylon
1
spacer, and / ‐ 28 locknut (FIGURE 11.10).
4
Nylon Spacer
Nylon
Washer
1
/ -28 Locknut
4
Vent Foot Tilt
Connecting Link
Part No 1160889
5
/ washer, and / ‐24 locknut. Tighten securely (FIGURE 11.9).
16 16
11
/ Nylon
16
Washers
7
/ Nylon Washer
8
FIGURE 11.9 Installing the Foot Tilt Release Pedal
Nylon
Washer
FIGURE 11.10 Installing the Vent Foot Tilt Connecting Link
1
/ inch mounting screw, two
4
5
/ -24
16
Locknut
Foot Tilt
Release Pedal
7
/
Coved Spacer
Coved Spacer
1 Inch Mounting Screw
103
SECTION 11—VENT TRAY
7
/ nylon washers,
8
1
2 / Inch Mounting Screw
4
Nylon Washer
8
Vent Tray Support Tube
NOTE: Vent tray and attaching
brackets not shown for clarity.
Solara®3G/Spree 3G