SECTION 9—TILT-IN-SPACE
After ANY adjustments, repair or service and BEFORE use, make sure all attaching
hardware is tightened securely - otherwise injury or damage may result.
REMOVING/INSTALLING TRIGGER RELEASE
LEVER WITH CABLE
NOTE: Refer to FIGURE 9.1 for this procedure.
REMOVING TRIGGER RELEASE WITH CABLE
1. Cut tie wrap that secures the cable to the back cane.
2. Remove the mounting screw and locknut that secures the trigger release lever to the
back cane as shown in Detail "A".
3. Remove the two (2) allen screws and washers that secure the cable to the bearing
housing as shown in Detail "B".
4. Remove existing trigger release lever with cable from the wheelchair.
5. Repeat STEPS 1-4 for opposite side, if necessary.
6. Install the new trigger release lever with cable. Refer to Installing Trigger Release with
Cable on page 52.
DETAIL "A"
Back Cane
Locknut
Trigger Release
Lever
FIGURE 9.1 - REMOVING/INSTALLING TRIGGER RELEASE LEVER WITH
Part No 1085787
WARNING
Mounting
Screw
Cable
Tie
Wrap
DETAIL "B"
Cable
Washer
Allen
Screw
CABLE
SECTION 9—TILT-IN-SPACE
Bearing
Housing
51
™
™
Solara
and Solara
Limited