Table of Contents
Advertisement
Find Quality Products Online at:
When you first look at the plot, the cursor is at the frequency
of the worst margin. To move the cursor to the worst value,
tap WORST VALUE (). The box at the bottom of the cursor
shows the frequency at the cursor's position.
To move the cursor to other points, touch and drag the yellow
circle at the top of the cursor.
To move the cursor in small increments, tap the yellow circle,
then tap the arrow buttons that show on the plot (
The overall result for the test. If you look at pairs, the result is
for those pairs. If the result shows an asterisk, see "PASS*/
FAIL* Results" on page 61.
To zoom in and out, use the pinch, reverse-pinch, and double-
tap gestures on the touchscreen. You can also use the zoom
controls to change the magnification on the frequency and
decibels scales independently. See Figure 3 on page 21.
DIAGNOSTIC and FAULT INFO Tabs
If the Autotest failed or had a marginal result, the FAULT INFO
tab shows. If the test passed and you selected All Autotests for
the HDTDR/HDTDX setting on the TEST SETUP screen, the
DIAGNOSTIC tab shows. These tabs give you access to the HDTDR
and HDTDX analyzer plots. The plots help you locate the causes of
NEXT and return loss failures. See the Technical Reference
Handbook.
GlobalTestSupply
www.
Certify Twisted Pair Cabling
Twisted Pair Autotest Results
or
).
71
.com
sales@GlobalTestSupply.com
Advertisement
Table of Contents
