Fluke Versiv Series User Manual page 23

Versiv Series Cabling Certification Product Family
Users Manual
10
Find Quality Products Online at:
•
Keep the module's OUTPUT ports covered with a
dust cap or keep a test reference cord attached. The
OUTPUT ports can emit radiation even when you do
not do a test.
•
When you inspect fiber endfaces, use only
magnification devices that have the correct filters.
•
Use the Product only as specified or hazardous laser
radiation exposure can occur.
W
To prevent damage to the tester or cables under
test and to prevent data loss:
•
Do not connect the tester to an active network.
Doing so causes unreliable test results, can disrupt
network operations, and can cause damage to the
module's receiver.
•
Use proper cleaning procedures to clean all fiber
connectors before every use. Neglecting this step or
using improper procedures can cause unreliable test
results and may permanently damage the
connectors. See Chapter 4.
•
Use a video probe to periodically inspect the
module's optical connectors for scratches and other
damage.
•
Do not connect APC (angled physical contact)
connectors to the output ports. Doing so can
damage the port's UPC endface and cause
unreliable test results.
•
To make sure your test results are as accurate as
possible, do the reference procedure frequently. See
"About the Reference for Fiber Tests" on page 143.
•
Use only high-quality test reference cords that
comply with the standards. See "About Test
Reference Cords and Mandrels" on page 146
GlobalTestSupply
www.
Caution
.com
sales@GlobalTestSupply.com