Table of Contents
Advertisement
Versiv Series Cabling Certification Product Family
Users Manual
How To Do an Auto SmartLoop Test
288
Find Quality Products Online at:
Set up the launch compensation function
On the home screen, tap the test setup panel.
1
On the CHANGE TEST screen, tap the button next to the Auto
2
SmartLoop test, then tap USE SELECTED.
If an Auto SmartLoop test is not available, tap NEW TEST to add
one to the project. Select settings as necessary on the TEST SETUP
screen. See "Settings for HDR OTDR Tests" on page 255.
Select three launch cords that have the same type of fiber as
3
the fiber you will test.
On the home screen, tap SET COMP.
4
On the SET LAUNCH METHOD screen tap SmartLoop.
5
Clean and inspect the OTDR port and connectors on the three
6
launch cords.
Make the connections shown in Figure 110.
7
Tap SET.
8
When the SET LAUNCH COMP screen shows, make sure the
9
tester shows the correct distances for the end of the launch
cord and the start of the tail cord.
If the fibers have APC connectors, the tester
possibly will not find the correct launch and tail
events. If this occurs, do the compensation again
and select Manual Entry to enter the lengths of the
cords manually.
10 Tap SAVE.
GlobalTestSupply
www.
Note
.com
sales@GlobalTestSupply.com
Advertisement
Table of Contents
