Table of Contents
Advertisement
Versiv Series Cabling Certification Product Family
Users Manual
120
Find Quality Products Online at:
To do the FiberInspector test:
Connect the FI-1000 probe to the type A USB port on the side
1
of the tester.
Or
Connect the type C end of the USB cord to the FI-3000 and the
type A end of the USB cord to the tester.
Install the appropriate tip on the Probe.
2
Turn on the Probe.
3
If necessary, turn on the tester.
4
Set up a FiberInspector test.
5
Clean the connector that you will inspect. See Chapter 4.
6
Insert the probe into a connector or patch cord adapter. See
7
Figure 48.
Figure 48. Inspect an Endface (FI-3000 shown)
GlobalTestSupply
www.
.com
sales@GlobalTestSupply.com
Advertisement
Table of Contents
