Fluke Versiv Series User Manual page 290

Find Quality Products Online at:
Clean and inspect the connectors on the launch and tail cords
1
or patch cords and the link to be tested.
Connect the launch cord to the OTDR port and the link to be
2
tested, as shown in Figure 107. Connect a tail cord to the far
end of the link if necessary.
Or, you can use a patch cord that is 1 m long at minimum to
connect the tester to the link. To see results for the far-end
connector, connect a tail cord or patch cord (>1 m) to the far end
of the link.
On the home screen, tap the test setup panel.
3
On the CHANGE TEST screen, tap the button next to the
4
FaultMap test, then tap USE SELECTED. If a FaultMap test is not
available, tap NEW TEST to add one to the project.
Tap TEST or press .
5
GlobalTestSupply
www.
Use the HDR OTDR
The FaultMap Test
281
.com
sales@GlobalTestSupply.com