Scr P Overview; Scr P Models; Scr P Features And Indicators - Banner SCR P Series Instruction Manual

3 SCR P Overview

Figure 1: Safety Controller SCR P

3.1 SCR P Models

Model Description
SCR P-10-6R-4 Configurable safety relay controller - 10 inputs (4 convertible), two 3-channel safety relay outputs,
Daisy Chain Diagnostic, Industrial Ethernet

3.2 SCR P Features and Indicators

Connection points are push-in spring clamp connectors.
Wire Size: 0.2 mm² to 2.08 mm², 24 to 14 AWG
Important: Clamp terminals are designed for one wire only. If more than one wire is connected to a
terminal, a wire could loosen or become completely disconnected from the terminal, causing a short.
Use a stranded wire or a wire with an accompanying ferrule. Tinned wires are not recommended.
After inserting the wire into the terminal, tug the wire to make sure it is properly retained. If the wire is not
retained, consider using a different wiring solution.
BERNSTEIN's SCR P configurable safety relay controller is an easy-to-
use and cost-effective alternative to safety relay modules. It replaces the
functionality and capability of two independent safety relay modules while
offering the configurability, simplicity, and advanced diagnostics
capabilities offered by the rest of the BERNSTEIN Safety Controller line-
up.
•
Intuitive, icon-based programming with drag-and-drop PC
configuration simplifies device setup and management
•
Two six-amp safety relay outputs, each with three N.O. sets of
contacts
•
Ten inputs, including four that can be used as non-safe
outputs
•
Innovative daisy Chain Diagnostic (DCD)
•
Automatic Terminal Optimization (ATO) can increase the inputs
from 10 to up to 14
•
Industrial Ethernet two-way communication
◦
256 virtual non-safe status outputs
◦
80 virtual non-safe inputs (reset, on/off, cancel off-delay,
mute enable)
◦
Provision of DCD diagnostic data
•
SCR P-FPS external drive for fast swap and quick
configuration without a PC (see
FPS on p. 181)
Figure 2: Features and Indicators
www.bernstein.eu - Tel: + 49 571 793 0
Programmable Safety Controller SCR P
SCR P: Using the SCR P-
9