Banner SCR P Series Instruction Manual page 147

Fault Bits
Slots 3 and 4 are always filled with 64-bits of Fault type virtual status output information from the Safety Controller.
Table 41: Safety Controller Fault Bits (0–31) Module (Ident 0×100) [fixed in Slot 3]
PLC Input Data Name
Fault bits 0–7
Fault bits 8–15
Fault bits 16–23
Fault bits 24–31
Table 42: Safety Controller Fault Bits (32–63) Module (Ident 0×100) {fixed in Slot 4]
PLC Input Data Name
Fault bits 32–39
Fault bits 40–47
Fault bits 48–55
Fault bits 56–63
Input Status Bits
Slots 5 through 9 are always reserved for 160 bits of Safety Controller input information. An expandable (XS26) safety
controller might have up to 154 inputs, if all of eight possible expansion cards were used as 16 channel inputs (in addition to
the 26 inputs built into the Base Controller).
Table 43: Safety Controller Input Status Bits (0–31) Module (Ident 0×100) [fixed in Slot 5]
PLC Input Data Name
Input Status bits 0–7
Input Status bits 8–15
Input Status bits 16–23
Input Status bits 24–31
Table 44: Safety Controller Input Status Bits (32–63) Module (Ident 0×100) [fixed in Slot 6]
PLC Input Data Name
Input Status bits 32–39
Input Status bits 40–47
Input Status bits 48–55
Input Status bits 56–63
Input Data Type PLC Output Data Name
Byte Not applicable
Byte
Byte
Byte
Input Data Type PLC Output Data Name
Byte Not applicable
Byte
Byte
Byte
Input Data Type PLC Output Data Name
Byte Not applicable
Byte
Byte
Byte
Input Data Type PLC Output Data Name
Byte Not applicable
Byte
Byte
Byte
www.bernstein.eu - Tel: + 49 571 793 0
Programmable Safety Controller SCR P
Output Data Type
Not applicable
Output Data Type
Not applicable
Output Data Type
Not applicable
Output Data Type
Not applicable
147