Table of Contents
Advertisement
Programmable Safety Controller SCR P
Optical safety devices must be placed at an appropriate safety distance (minimum distance), according to the application
standards. Refer to the applicable standards and to manufacturer documentation specific to your device for the appropriate
calculations. The response time of the Safety Controller outputs to each safety input is provided on the Configuration
Summary tab in the Software.
If the application includes a pass-through hazard (a person could pass through the optical device beams and stand
undetected on the hazard side), other safeguarding may be required, and manual reset should be selected (see
Reset Input
on p. 36).
6.4.8 Two-Hand Control
The Safety Controller may be used as an initiation device for most powered machinery when machine cycling is
controlled by a machine operator.
The Two-Hand Control (THC) actuators must be positioned so that hazardous motion is completed or stopped before the
operator can release one or both of the buttons and reach the hazard (see
Distance)
on p. 27).
The Safety Controller safety inputs used to monitor the actuation of the hand controls for two-hand control comply with the
functionality of Type III requirements of IEC 60204-1 and ISO 13851 (EN 574) and the requirements of ANSI NFPA79 and
ANSI B11.19 for two-hand control, which include:
•
Simultaneous actuation by both hands within a 500 ms time frame
•
When this time limit is exceeded, both hand controls must be released before operation is initiated
•
Continuous actuation during a hazardous condition
•
Cessation of the hazardous condition if either hand control is released
•
Release and re-actuation of both hand controls to re-initiate the hazardous motion or condition (anti-tie down)
•
The appropriate performance level of the safety-related function (Control Reliability, Category/Performance level, or
appropriate regulation and standard, or Safety Integration Level) as determined by a risk assessment
WARNING: Point-of-Operation Guarding
When properly installed, a two-hand control device provides protection only for the hands of the machine
operator. It may be necessary to install additional safeguarding, such as safety light screens, additional
two-hand controls, and/or hard guards, to protect all individuals from hazardous machinery.
Failure to properly guard hazardous machinery can result in a dangerous condition which could lead to
serious injury or death.
CAUTION: Hand Controls
The environment in which hand controls are installed must not adversely affect the means of actuation.
Severe contamination or other environmental influences may cause slow response or false On conditions
of mechanical or ergonomic buttons. This may result in exposure to a hazard.
The level of safety achieved (for example, ISO 13849-1 Category) depends in part on the circuit type selected.
Consider the following when installing hand controls:
•
Failure modes, such as a short circuit, a broken spring, or a mechanical seizure, that may result in not detecting the
release of a hand control
•
Severe contamination or other environmental influences that may cause a slow response when released or false ON
condition of the hand control(s), for example, sticking of a mechanical linkage
•
Protection from accidental or unintended operation, for example, mounting position, rings, guards, or shields
•
Minimizing the possibility of defeat, for example, hand controls must be far enough apart so that they cannot be
operated by the use of one arm—typically, not less than 550 mm (21.7 in) in a straight line, per ISO 13851
•
The functional reliability and installation of external logic devices
•
Proper electrical installation per NEC and NFPA79 or IEC 60204
CAUTION: Install Hand Controls to Prevent Accidental Actuation
Total protection for the two-hand control system from defeat is not possible. However, the user is
required by U.S. and International standards to arrange and protect hand controls to minimize the
possibility of defeat or accidental actuation.
26
www.bernstein.eu
- Tel: + 49 571 793 0
Two-Hand Control Safety Distance (Minimum
Manual
Advertisement
Table of Contents
