Table of Contents
Advertisement
57413
8/16/03
11:50 PM
Attaching the Controller
The power may be ON while attaching the controller to the sensor.
A coiled cord with modular plugs is supplied with the PRC1 controller. Insert one plug into the
sensor and the other plug into the controller. Be sure they click into place.
NOTE:
For complete PresencePLUS sensor and system setup instructions, see the
PresencePLUS P1B65Q Pixel-Counting Sensor Instruction Manual (P/N 56910), supplied with
each sensor.
CAUTION . . .
!
Avoid damage to sensor caused by electrostatic discharge (ESD).
Use a properly-connected ESD wrist strap or other proven method for preventing
electrostatic discharges when installing a lens or attaching a cable.
Banner Engineering Corp. • Minneapolis, MN
www.bannerengineering.com • Tel: 763.544.3164
Page 3
U.S.A.
P1B65Q
Coiled Cord
(Supplied with PRC1 )
MQDC-6 Series
Cable
PRC1
To P ower Source,
Trigger Device, and
Output Receivers
Controller Connection to the Sensor
P/N 57413
OVERVIEW
TM
Controller
SETUP
ROI
TEACH
RUN
RUN
RUN
MAIN
P/F
JUDGE
MAIN
IMAGE
CONFIG
MENU
CNTRL
LOAD
HELP
ENTER
3
Advertisement
Table of Contents
