Table of Contents
Advertisement
WARNING:
•
Complete the Commissioning Checkout Procedure
•
Failure to follow the commissioning process may lead to serious injury or death.
•
After confirming the configuration, the Safety Controller operation must be fully tested
(commissioned) before it can be used to control any hazards.
Saving a Configuration:
1. Click
Save Project.
2. Select Save As.
3. Navigate to the folder where you wish to save the configuration.
4. Name the file (may be the same or different from the configuration name).
5. Click Save.
Confirming a Configuration (the Safety Controller must be powered up and connected to the PC via the USB cable):
1. Click
.
2. Click Write Configuration to Controller.
3. If prompted, enter the password (default password is 1901).
The Entering config-mode screen opens.
4. Click Continue to enter the configuration mode.
After the Reading Configuration from the Controller process is completed, the Confirm Configuration screen opens.
5. Verify that the configuration is correct.
6. Scroll to the end of the configuration and click Confirm.
7. After the Writing Configuration To Controller process is completed, click Close.
Note:
•
•
•
If you are configuring an SCR P, the Do you want to change the passwords of the controller? screen may
display.
8. SCR P: If prompted and if desired, change the SCR P passwords.
9. Cycle power or perform a System Reset for the changes to take effect in the Safety Controller.
10. Save the confirmed configuration on the PC.
Note: Saving the now confirmed configuration is recommended. Confirmed configurations are a
different file format (.xcc) than an unconfirmed file (.xsc). Confirmed configurations are required for
loading into an SCR P-FPS drive. Click Save As to save.
7.4.1 Notes on Confirming or Writing a Configuration to a Configured
SCR P
User settings and passwords affect how the system responds when confirming a configuration or writing a confirmed
configuration to a configured SCR P Safety Controller.
User1
1. Click Write configuration to Controller to confirm a configuration (or write a confirmed configuration) to a
configured Safety Controller.
2. Enter the User1 password.
3. The confirmation (or writing) process begins.
At the end of the confirmation (or writing) process, the Safety Controller will have received:
•
New passwords
•
New configuration Network settings are not changed.
Network settings are sent separately from the configuration settings. Click Send from the
Network Settings window to write the network settings to the Safety Controller.
SCR P: Network settings are automatically sent only if the SCR P is a factory default
Safety Controller. Otherwise, use the Network Settings window.
SCR P: Passwords are automatically written only if the SCR P is a factory default Safety
Controller or the configuration is confirmed. In any other case, use the Password Manager
window to write passwords to an SCR P.
www.bernstein.eu
Programmable Safety Controller SCR P
- Tel: + 49 571 793 0
57
Advertisement
Table of Contents
