Sample Configurations - Banner SCR P Series Instruction Manual

Programmable Safety Controller SCR P
User2 or User3—Successful Configuration Confirmation or Writing
This scenario assumes the following settings for User2 or User3:
•
Allowed to change the configuration = enabled
•
Allowed to change the network settings = enabled OR disabled
1. Click Write configuration to Controller to confirm a configuration (or write a confirmed configuration) to a
configured Safety Controller.
2. Enter the User2 or User3 password.
3. The confirmation (or writing) process begins.
At the end of the confirmation (or writing) process, the Safety Controller will have received:
•
New configuration
Passwords and Network settings are not changed.
User2 or User3—Unsuccessful Configuration Confirmation or Writing
This scenario assumes the following settings for User2 or User3:
•
Allowed to change the configuration = disabled
•
Allowed to change the network settings = enabled OR disabled
1. Click Write configuration to Controller to confirm a configuration (or write a confirmed configuration) to a
configured Safety Controller.
2. Enter the User2 or User3 password.
3. The confirmation (or writing) process is aborted.

7.5 Sample Configurations

The Software provides several sample configurations that demonstrate various features or applications of the Safety
Controller. To access these configurations, go to
The SCR P has eight sample configurations. These samples include typical applications of the SCR P model. Use the
samples as a starting point and modify them for your specific needs.
58
Open Project > Sample Projects and select the desired project.
www.bernstein.eu - Tel: + 49 571 793 0