Table of Contents
Advertisement
6 Installation Considerations
6.1 Appropriate Application
The correct application of the Safety Controller depends on the type of machine and the safeguards that are to be
interfaced with the Safety Controller. If there is any concern about whether or not your machinery is compatible
with this Safety Controller, contact BERNSTEIN AG.
WARNING: Not a Stand-Alone Safeguarding Device
This BERNSTEIN device is considered complementary equipment that is used to augment safeguarding
that limits or eliminates an individual's exposure to a hazard without action by the individual or others.
Failure to properly safeguard hazards according to a risk assessment, local regulations, and relevant
standards may lead to serious injury or death.
WARNING: User Is Responsible for Safe Application of this device
The application examples described in this document depict generalized guarding situations. Every
guarding application has a unique set of requirements.
Make sure that all safety requirements are met and that all installation instructions are followed. Direct
any questions regarding safeguarding to a BERNSTEIN application engineer at the number or addresses
listed this document.
WARNING: Read this Section Carefully Before Installing the System
The BERNSTEIN Safety Controller is a control device that is intended to be used in conjunction with a
machine safeguarding device. Its ability to perform this function depends upon the appropriateness of
the application and upon the Safety Controller's proper mechanical and electrical installation and
interfacing to the machine to be guarded.
If all mounting, installation, interfacing, and checkout procedures are not followed properly, the Bernstein
Safety Controller cannot provide the protection for which it was designed. The user is responsible for
satisfying all local, state, and national laws, rules, codes, or regulations relating to the installation and use
of this control system in any particular application. Make sure that all safety requirements have been met
and that all technical installation and maintenance instructions contained in this document are followed.
6.2 SCR P Applications
The SCR P Safety Controller is ideal for any small to medium size machine that would typically use two independent safety
relay modules.
Muting Indicator Lights
Hazardous Area
Figure 5: SCR P Sample Application 1
www.bernstein.eu
- Tel: + 49 571 793 0
Programmable Safety Controller SCR P
Safety Light Screens
HMI
E-Stop Buttons
17
Advertisement
Table of Contents
