Banner SCR P Series Instruction Manual page 173

LED Status
Off
Sequence:
All
Green On for 0.5 s
Red On for 0.5 s
Off for 0.5 s minimum
Green: Solid
Green: Flashing
Power/Fault (1)
Red: Flashing
Green: Solid
Green: Flashing
Green: Fast flashing for 3 s, then
solid
Green: Flashing for 3 s, then solid
USB (1)
Green: Flashing for 3 s, then Red:
Flashing
Red: Solid
Red: Flashing
Green: Solid
Green: Solid
Inputs (10) Red: Solid
Red: Solid
Red: Flashing
Green: Solid
RO1, RO2 (2) Red: Solid
Red: Flashing
Ethernet Diagnostic LEDs
Amber LED
On
Off
Amber LED and Green LED Flash in Unison
5 flashes followed by several rapid flashes
1 flash every 3 seconds
2 flash repeating sequence
3 flash repeating sequence
4 flash repeating sequence
Meaning
Initialization Mode
Power applied
24 V dc connected
Configuration or Manual Power-Up mode
Configuration via SCR P-FPS: Cycle Power
Non-operating Lockout condition
USB cable connected or SCR P-FPS plugged in
Factory default Safety Controller: no USB cable connected or SCR P-FPS plugged in
Configured (locked or unlocked) SCR P-FPS plugged into a factory default Safety
Controller; the configuration, network settings, and passwords transfer from the SCR P-
FPS to the Safety Controller
Configured and unlocked SCR P-FPS plugged into a configured Safety Controller with a
matching configuration and matching passwords
Configured and locked SCR P-FPS plugged into a configured Safety Controller with a
matching configuration and matching passwords, but mismatched network settings
Configured Safety Controller: no USB cable connected or SCR P-FPS plugged in
Configured (locked or unlocked) SCR P-FPS plugged into a configured Safety Controller
with a mismatched configuration, a mismatched password, or a blank SCR P-FPS plugged
into any Safety Controller
24 V dc and no fault
Input configured as status output and active
0 V dc and no fault
Input configured as status output and inactive
All terminals of a faulted input (includes shared terminals)
On (contacts closed)
Off (contacts open) or not configured
Safety Output fault detected or EDM fault detected or AVM fault detected
Green LED
Varies with traffic
Off
www.bernstein.eu
Programmable Safety Controller SCR P
Note: If there are mismatched network settings, the network
settings transfer from the Safety Controller to an unlocked SCR P-
FPS. Network settings do not transfer to a locked SCR P-FPS.
Description
Link established/normal operation
Hardware failure
Description
Normal power up
Contact BERNSTEIN
In the past 60 seconds, a cable was unplugged while active
A cable is unplugged
Network not enabled in the configuration
- Tel: + 49 571 793 0 173