Programmable Safety Controller SCR P
8.17
Simulation Mode
The Simulation Mode tab becomes accessible when
options become available on the left side of the screen. The Simulation Mode tab contains view only information; you
cannot click on the output or input items in this view.
Note: For DCD inputs, individual devices are not simulated, only the final output that is connected to
the SCR P input terminals is simulated (on or off).
Simulation Speed—Sets the speed of the simulation.
104
Figure 90: Simulation Mode
Simulation Mode is clicked on the toolbar. Simulation Mode
[Play/Pause] Starts the simulation time running at the specified simulation speed or
temporarily stops the simulation time.
[Single Step] Advances the simulation time at the specified step interval.
[Reset] Resets the timer to zero and the equipment to the initial stop state.
[Timer] Displays elapsed time in hours, minutes, seconds, and thousandths of a
second.
www.bernstein.eu
- Tel: + 49 571 793 0