Programmable Safety Controller SCR P
Note: Make sure that Disable Automatic Terminal Optimization Feature checkbox is selected.
Figure 126: Disable Automatic Terminal Optimization Feature Selected
The project is created.
4. On the Equipment tab, click
The Add Equipment window opens.
5. Add an Emergency Stop button and click OK to accept the default settings.
6. Click
.
7. Add an Optical Sensor and click OK to accept the default settings.
8. Click
.
9. Add a Gate Switch and click OK to accept the default settings.
10. Go to the Wiring Diagram tab and notice the terminals that are used.
178
below the Safety Controller.
www.bernstein.eu
- Tel: + 49 571 793 0