Table of Contents
Advertisement
Removing the BOSS-N1 module
Prerequisites
1. Follow the safety guidelines listed in the
2. Follow the procedure listed in the
3.
Remove the riser 1A
for Intel GPU configurations or
Steps
1. Pull and lift the BOSS-N1 card carrier retention latch lock to open.
2. Slide the BOSS-N1 card carrier out.
Figure 51. Removing the BOSS-N1 card carrier
3. Using the Phillips 1 screwdriver remove the M3 x 0.5 x 4.5 mm screw that secures the M.2 SSD to the BOSS-N1 card carrier.
4. Slide the M.2 SSD out from the BOSS-N1 card carrier.
Safety
instructions.
Before working inside your
Remove the riser 1B
system.
for NVIDIA GPU configurations.
Installing and removing system components
89
Advertisement
Table of Contents
