Installing The Pdb For Intel Gpu Configurations - Dell PowerEdge XE9640 Installation And Service Manual

Figure 165. Removing the PDB
Next steps
Replace the PDB for Intel GPU

Installing the PDB for Intel GPU configurations

Prerequisites
1. Follow the safety guidelines listed in the
2. Follow the procedure listed in the
3. Disconnect the cables from the connector on the system board and the storage tray.
4. Remove the storage tray.
5. Remove the risers.
6. Remove the VSB cables from the system
7. Remove lower brace cover.
8. Disconnect all the cables from the system board and make note of all the cable connections. For more information, see
Cabling diagram.
9. Disconnect the liquid cooling tubes from the Manifold for DLC module and keep in on the system board and make sure do not
damage any connectors on the system board.
10. Remove the system board
11. Disconnect the liquid cooling tubes from the Manifold for the connectors 6, 7, 8.
12. Remove the VSB cables from the
13. Disconnect the cables from the connector on the PDB.
14. Remove the power supply
Steps
1. Holding the blue holders, align and insert the PDB into the chassis. Using the Phillips 2 screwdriver, tighten the screws to
secure the PDB in to the chassis.
178 Installing and removing system components
configurations.
Safety instructions.
Before working inside your system
board.
tray.
PDB.
units.
.